Pack of 100 pcs 965nm 50mW 5μm Aperture TO-18 Laser Diode

Description

Pack of 100 pcs 965
nm 50mW 5μm Aperture TO-18 Laser Diode
Description:
This is a pack of 100 pcs 965nm single mode laser diode, which can output 50mW optical power from its 5μm aperture. It was p-up bonded on TO-18 (5.6mm TO can), which was made in the USA. It came to us with a lot of other electronic/opto-electronic related surplus. We have 375 such lasers in stock. The lasers are brand new not used.
Specifications:
Characteristics
Specification
965nm 50mW TO-18 Laser Diode
CW output power (W)
0.05
Peak wavelength (nm)
965
-- 968
Spectral width (nm)
≤
1.0
Threshold current (A)
≤
0.020
Operating current (A)
≤
0.10
Slope efficiency (W/A)
≥
0.6
Beam divergence θ
∥
×
θ
⊥
(deg.)
8/30
Wavelength temperature coefficient (nm/
℃
)
0.3
Emitting area (μm)
5
×
1
Lifetime(hour)
>10,000
Photodiode
Anode Ground PD
Package
TO-18 (5.6mm TO can)
Data Sheet
Available for each diode
By Bidding, you must agree and accept:
·
You are over 18 years old and understand the dangers and risks of laser use, and will use this component responsibly.
·
You will use this component in a legal, safe manner to ensure audience and personnel safety.
·
You have a working knowledge of laser diodes. You understand ESD, and the static sensitivity of this component.
·
Laser beam is harmful for eyes during process. Please avoid any directly see on the aperture. Never shine laser beam on human or animals.
·
You accept these diodes as electronic components for integrating them into a system designed by yourself. You relieve the SELLER, and E-bay from any and all LIABILITY from damage or injury that may arise from use of this laser.
If you are not serious, please do not place a bid.
Return policy:
·
We will test the lasers before shipment; buyer should contact us as soon as he find it is defective;
·
Refund request should be made within 14 days buyer receives the product;
·
Replacement request should be made within 30 days buyer receives the product;
·
Since this is a Do-It-Yourself laser diode, we only refund if the product arrive to be defective; so please use it gently and properly when you assemble your device; you also need to send back in original shape to get refund/replacement; we won't refund or replace if the laser was damaged by buyers;
Some tips for operating laser diode:
·
Please use a power supply with stable output. Transient current spikes should be avoided.
·
Please always connect the pins correctly.
·
Heat sink with good thermal dissipation is required for holding the laser otherwise the laser will be burned.
·
Please use eye protection when you operate the laser.
·
It is better to wear an antistatic wrist band.
·
You should always start with current well below the diodes maximum (about 0.12 amps in this case).